This is an upgrade to V-Spooler-X by @FyrbyAdditive. Agreed with him to publish this model.

Replaces part of gantry/guide.

Requires:

• 100mm linear rod - 6mm diameter (if you want to be super neat - can be cut flush)
• 1x LM6UU bearing
• 2x heat inserts as per original v-spooler/v-spooler x (can be salvaged from old part with bearings)
• 4x heat inserts m3 x 4.2x3
• 4x m3x3 grub screws
• 4x m3x14mm shcs/bhcs (similar to those used in v-spooler)

Assembly is straightforward:

• Print the parts (2 rail mounts and one guide)
• Insall all heat inserts
• Insert bearing into guide and affix it with 2 grub screws.
• Replace guide from original gantry: 
  • unscrew m3x8 from guide base on your respooler and affix rail mounts with m3x14 - do one side at a time.
• Insert linear rod through mounts and mount