A pegboard holder suitable for multimeters.

There is a version that has the peg pre-installed in the bracket, and another version that designs the peg as a separate component

Version 2:
The bracket is equipped with a peg, and a customized support structure has been reserved for the peg in the model!!
When printing, you can set it to be without support normally. After the printing is completed, you can gently break off the built-in support and remove it.

Version 1:
The peg is designed as an independent component with a large assembly gap. It is recommended to use hot melt adhesive to fix it!
The curved peg is used for the top hole and needs to be installed at an upward angle; the straight peg is used for the bottom hole.

This stand is compatible with multimeters with a base size of approximately 2.5 inches × 1.75 inches.

Suitable for pegboards with a hole spacing of 1 inch.

When printing the support structure and the peg, please make sure that the base plate and the printing platform are completely aligned and flat.

If you've successfully made this stand, please feel free to share your results! I'm really looking forward to seeing it in person!

Anet A8

No support is needed

20%