This replaces the insert for the center stem mount from Lezyne. The three holes are spaced at 10mm, and there is one version for using brass inserts (M3) and one to thread directly into the part. This should allow you to screw a GPS mount puck into the top like some of those for K-Edge and whatnot that others have posted here, as the outer two mounting holes are 20mm apart. The center hole simply allowed me to break a Wahoo mount into two pieces for easier printing. The two gaps on the sides allows the wings room to flex for the locking bit. Note: The part will leverage against the base.

Update: Added a lower profile version intended for threaded inserts that sits closer to the top of the mount base. Added some minor chamfers to the design becauseflourish

Re-update: Wahoo mounts are offset 90 for what I expected. Added a base to reflect this.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: Polymaker ASA Black

Category: Sport & Outdoors