Minimalistic model to hold the ubiquitous 100W PTC heater with fans used to keep resin printer enclosures heated.  Designed to hold heater using 2 M4x60mm hex standoffs.  Needs two M4 flat head screws on bottom and two pan head screws on the top to assemble.  A 0.25-inchØ x  0.25-inch magnet is installed to hold the mount in position but allow quick removal when needed.  Need to file a hole in rear of enclosure for wires to pass.  Mount has features for wire tie to secure wires in place to mount.

I've run it at 35°C without any problems.  Printed in PLA+ 0.3mm layer height.

https://www.amazon.com/Mecion-Female-Standoff-Hexagon-Threaded/dp/B088FJXWR2

https://www.amazon.com/gp/product/B0BNZQFWHN

https://www.amazon.com/gp/product/B0BHY57L7D/