I designed 3 models based of an original HSM4 remote holder. 

Model 1 removes the screw hole and clip clamp providing a flat surface to stick the holder against any surface using double sided tape.

Model 2 is an “exact” replica of the original model. 
*exact meaning most measurements were taken with a caliper, but some had to be changed to enable physical strength or orientation to 3D print! 

Model 3 is the same as model 2, but with some changes to the back side to ensure better printer compatibility! 

In case something doesn't fit right away, please let me know and I will provide updated models!
Only the fitment of the remote itself is tested, the screw hole and clip slot are based of of measurements.

Printing:

The model can easily be printed on its back with a few auto tree supports. 
0.2mm PLA standard settings is plenty for this model!