A simple flat mount for a Pi Zero 2 with attached Zerocam that includes a ¼ inch tripod mount.

The Pi is attached using M3 nut/bolts.

The Zerocam is held in position using pins, it has an adhesive sticker on the back that can be used to secure it in place.

The slot is to allow space for  header pins.

It is printed in two parts, which can be connected using ‘SuperGlue’. Printing as a single part required too much support material, this version can be printed without any support material.

Printed in black PETG on a Prusa MK3S+ using 0.2mm layer height.