Contrabass Cart
Drab Wall77
Mit KI Ähnliches finden
Druckprofil(0)
Modelldatei(0)
0
0
0
Veröffentlicht:2026-03-03 15:50:35
0
0
000Beschreibung
Tags
Modellquelle
Rezensionen(0)
| Item | Quantity | Supplier | Cost | Part Number |
| Lawnmower Wheels | 2 | Menard's | 9.99 | 2642356 |
| ½"- 13 Threaded rod, 2ft long | 1 | Menard's | 4.98 | 2289259 |
| ½"-13 Nut | 4 | Menard's | 2.19 (18-pack) | 2325631 |
| Platform Piece | 1 | Varies (~250g) | N/A | |
| Loctite Threadlocker | 1 | Menard's | 6.28 | 2514977 |
- Print out your 3d printed platform. On my X1, it took about 8 hours on base settings. I used 15% infill.
- Put one nut on the very end of the rod and loctite it into place.
- Add one of the wheels so it is touching the nut.
- Add a second nut after the wheel and loctite that into place. It should not be so cloce tot he wheel that it makes it difficult for the wheel to freely spin, but not so far that the wheel wobbles.
- Add your platform piece to the rod. There is a hole slightly larger than the diameter of the threaded rod on the side of the platform. Th platform should be pressed up against the nut.
- Add a third nut after the platform piece. DO NOT LOCTITE THIS YET.
- Add your second wheel
- Add your fourth nut. DO NOT LOCTITE YET
- Mark the leftover threaded rod, remove the two nuts and wheel, and cut to proper length. I used a hacksaw since its zinc.
- Go back and add your two nuts, with loctite this time, and the wheel.
- Allow loctite time to dry and you should be complete. Use the long openings to add straps of your choosing and enjoy!
Tags
Modellquelle
Original-Link: Details anzeigen
CC0