Here's a cute little mouse that only needs supports for the ears. Perfect for a desk pet, potted plant buddy, or home decor. Print size at 100% is just shy of 70mm/2.75 in. Can be scaled down to 50% (pictured)

If this looks familiar, it's my bunny figure with different ears and tail. 

Printed on Ender 3v2 in PLA

Supports: yes (only needed for ears)

Infill: recommend at least 10%

Walls: 2

Bed adhesion: skirt/none

I'm new to modeling - any suggestions are appreciated

I prefer sharing with attribution but I'm not going to come after you - I just like attention