Since limited options are available for printing mounts for the CADDX Firefly micro FPV Camera, I tinkered this one up. It is low profile, lightweight, and fits Tiny Whoop Canopies.

I like to modify the canopy by cutting the back end off for ventilation as well as access to the channels.

I printed in PCTPE as its very strong and flexible. High Detail and Slow.

I used a 15 degree camera angle but a little adjustment when setting you could make it more or less.

I dab a little CA glue when I have the camera positioned, but mount does hold ok without.

This was the first run but seemed to do the job.

Appreciate any of Your Likes and Support!