A friend wanted something bigger than the normal tower, so I decided to stack some parts. This was not a change of the original STL since it uses a bottle, but it did take inspiration from the other remix of the shroud that is also remixed (https://www.thingiverse.com/thing:3333718). I made it in F360 myself, so it isn't an exact replica of that, but its pretty dang close. No doors, no windows, just walls. Print these as well as the stairs from the original design AND the remixed bottle shroud as mentioned above since these don't have the door.

A quick note: My details below assume it has already been scaled down the proper 96.71% to fit the original design as described on their thing. I do not have the other version, so your mileage may vary.

THIS NEEDS TO BE SCALED UP TO 101% IN EVERY DIRECTION, or else the fit will be too tight. I have included the STEP file in case some brave folks want to change it up (its a bit messy, mainly just circular and rectangular patterns). I hope you enjoy it as much as I do seeing someone have to stand up to roll their dice since they stacked 8 of these bad boys together. Good luck, and may the dice gods be ever in your favor!

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Notes:

Category: Toy & Game Accessories