This is not really a remix, more like added instruction and wiring diagram from the original design by mojama (https://www.thingiverse.com/thing:4343696)

Filament: PLA
Infill: 40-50%
Toggle switch: https://www.amazon.com/dp/B078KBC5VH
Wire: about 30 inches of 16awg wire https://www.amazon.com/dp/B07FMLVF84
Connector: Female Spade https://www.amazon.com/dp/B01N1WWR7E
Heat shrink tubes

#########################
Add the below 2 lines to the end of "End G-code" in Cura settings
You can edit the "Wait" time fits you, it's in seconds
#########################
G4 S120 ;Wait 2 minutes to cool
G1 X0 Y235 ;Present print

#########################
This is my End G-code:
#########################
G91 ;Relative positioning
G1 E-2 F2700 ;Retract a bit
G1 E-2 Z0.2 F2400 ;Retract and raise Z
G1 X5 Y5 F3000 ;Wipe out
G1 Z10 ;Raise Z more
G90 ;Absolute positioning

M106 S0 ;Turn-off fan
M104 S0 ;Turn-off hotend
M140 S0 ;Turn-off bed

G4 S120 ;Wait 2 minutes to cool
G1 X0 Y235 ;Present print