Exercise Bike Timer Holder
model.terrain
Mit KI Ähnliches finden
Druckprofil(0)
Modelldatei(0)
0
0
0
Veröffentlicht:2026-03-29 02:48:41
0
0
000Beschreibung
Tags
Modellquelle
Rezensionen(0)
Our very basic exercise bike has no timer, so this is a simple clamp to hold a kitchen timer. The clamp is secured with a VELCRO® brand One-Wrap® thin cable tie.
As designed, the clamp fits around a ~36 mm diameter foam-covered bar. The timer used has a chunky clamp which means the holder needs a lot of clearance to fit through. Consequently, it's a bit loose but won't fall out.
VELCRO® and One-Wrap® are registered trademarks of Velcro BVBA.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2 mm
Infill:
20 %
Filament: eSun PLA+ n/a
Notes:
You probably don't need a raft, but you might want a brim to help with adhesion.
You*definitely* need supports with this design, but check in your slicer before printing to ensure that there's no support in the channel for the cable tie. Any support here will be**really** hard to remove. For me, using Cura, I found that increasing the*Support X/Y Distance* slightly (from 0.7 to 1.0 mm) made the problem go away.See the bar clamp support image for details.
Tags
Modellquelle
Original-Link: Details anzeigen
CC-BY-SA