Some of you may know that if you leave the SD card inserted inside the iX12, it causes significant battery drain. Since I never like being without my SD card for my transmitter, I made this to hold the SD card for my iX12.

It simply press-fits into the 4 holes on the back of the transmitter and hold yours SD card for you. It's not fancy or complicated, but it works pretty good. I made two types, the one which stores your SD card vertically and another that stores it 90° to the side. I find the side-accessible version to be much easier to remove the SD card from, but the vertical design makes me feel a bit safer knowing that gravity will make sure the card doesn't go anywhere.

I printed these with tree supports in Cura and it worked really well.

As with most of my stuff, this is a work in progress. I might make some small tweaks and changes to optimize the design.

Creality

Ender 3

No

Yes

.01

15%

I printed these with tree supports in Cura and it worked really well.