Sputnik SP99 props guard. 4 pieces by guards : motor mount/3arms/the guards itself.
There is 4 set (front left / front right / rear left / and rear right) which are all specific. Nothing to distinguish each one from the other except it doesn't fit well.........

I've print the motor Mount in Flex filament, it gives smoothness and could be used as motor protection (small!!).

I haven't glued anything, so it can be changed and unmounted easily.

No support needed.

Up!

Up Plus2

No

No

0,25

10%

As arms are really small pieces, I had to cut a little bit on the upper angle.

I've tryed to make a clipsable design but it's really too small to be effective.