This is a simple wire management part that slips into a 20X20 T-Slot frame and becomes a wire and cable holder. Just drop the T-Protrusion into the T-slot of the frame and 'rotate' the cable guide 90 degrees. It is then held in the T-SLOT without any additional screws or hardware. Slip a TyWrap through the slot and mind your wires in place. Prints in about 10 Minutes.

2-15-2018 UPDATE - Added 2nd design which is a smaller, simplified clip. It works the same way but doesn't have the 'long-arm' design. Both work well but version 2 is smaller and prints a little quicker.