Summary

Hello again, I learned how to make bolts/screws etc. in Sketchup and thought "hey, why not some cool little jars?"

****UPDATE - IMPORTANT!! I just fixed the backwards thread issue - its all good now - thanks! Also fixed the crooked geometry with the lid, which was causing some strange buildup on the bottom layer.

Nov 16 edit - made the wide jars/lids/slotted lids more manageable without having to scale them down, and will make them easier to print. Large jars are rather long print times at 30% infill on .20 mmm layer height

So those of you who downloaded it earlier, swap those files out for these new updated files before you burn precious filament :) *****

I Just added a slotted lid for the wide jar so you can use it as a change jar...

I uploaded them as sets in varying sizes, each set with a jar and its compatible lid, and as individual pieces if you want to print them in different colors.

I printed these at low resolution (.20 mm) in PLA with 30% infill and they take three to five hours on average for the small and medium sized jars, respectively. No supports required, nothing special or fancy here.... enjoy!