Hanger Rod Mount – 1" Dowel Bracket with Mounting Holes

This sturdy, no-frills bracket is designed to hold a standard 1-inch wooden dowel securely for use as a closet rod or hanging bar. It features a drop-in slot for quick installation and three screw holes for solid wall or surface mounting.

🧱 Designed for:

• 1" (25.4mm) diameter dowel rods
• Laundry closets, wardrobes, utility spaces
• Wall or vertical surface mounting (e.g., into studs)

✅ Features:

• Drop-in slot: no need to slide the rod in from the end
• Three recessed screw holes for strong, stable attachment
• Gravity-based retention: no clips or ties needed
• Simple to print, install, and use

🖨 Print Settings:

• Material: PLA, PETG, ABS, or other rigid material (not TPU)
• Infill: 100% recommended for maximum strength
• Orientation: Flat backplate on the print bed
• Supports: None required

🔩 Mounting Tips:

• Use #8 or M4 screws, ideally into wood/studs
• If mounting to drywall, use appropriate anchors
• Recommended spacing: pair with a second bracket at the opposite end of your dowel span

🧰 Notes:

• Gravity alone holds the rod in place if properly installed
• Designed for typical closet use (shirts, pants, jackets on hangers)
• Tested with ~1 meter span and moderate load with no deformation