Inspired by your local skate shop's board display, I wanted a mount that displayed the bottom of the deck rather than mounting it with the grip tape facing outwards which stops your nasty wheels from marking up the wall.

I wanted something small and durable so they weren't too big and bulky, and was quick to print. These print in around an hour each mount at .4 quality and 150mm/s with any standard printer.

WARNING - PLEASE READ:
You MUST print these flat on the bed and not standing to ensure durability, you MUST use 25% infill, any less may cause failure on the 45 degree corner, I have tested it. These are NOT for snowboards or skiis, Longboards may require 3 due to weight. Make sure to use drywall plugs if you are mounting into direct drywall.