IMPORTANT:

USE THE ZIP FILE! THE STL DOES NOT WORK!

It should be found under other files

Steps:

1. Download and extract zip file
2. Use the one that takes the type of filament you are using(PLA, ABS ,PETG)
3. Use the built-in Sidewinder feature “Level” to barely touch the nozzle to the bed.
4. Start up the print
5. wait for the first square to print
6. If it is too squished then lower the bed. If it is too tall then lower the bed.
7. Finish the print as it prints each square, pauses for TEN SECONDS, then moves to the next.
8. Done! Your bed should now be perfectly level! If not, run the print again to ensure perfection.