A little wall mount for your Mavic 2.
 

Do you need the clip?
You technically only need the base print (see picture 3) although the stability is questionable. With the clip I mostly end up sliding my drone into the mount which ended up working out better than the original clip functionality. This might just be because I've never had to design a clip before this.

Battery in?

The mount works better without the battery in and is less likely to fall off, it's also a bit looser fit with the props on the clip but especially if you actually clip it in having the battery on the drone can work fine.

Compatibility
Tested and working with a Mavic 2 pro. I don't have a 2 air to test with, but it'll probably work. The base works with a 3 pro, but the clip will need to be redesigned to accommodate the slightly different arm geometry.


Mounting

I just used vhb tape for mounting since it's really strong and works well enough. If you need, I can throw together a version with some countersunk holes for mounts or whatever else