Got tired of broken handles on our washing baskets, not broken enough to throw away, just annoying. So a quick tinker in TinkerCAD and we have some repaired handles, been going a few months now, used eSUN PLA+ (my new favourite PLA filament)

Some post printing was required, warmed up with a hard dryer, and then curve it slightly to fit the basket better, was easier(aka LAZY) to design and print as flat.

TEVO

Tarantula

No

No

0.2

40%

After printing I warmed up with a hair dryer to curve it, in the shape of the basket(s)

After printing I warmed up with a hair dryer to curve it, in the shape of the basket(s)