A strain relief for pull-down kitchen faucet hose. The strain relief maintains a constant bend radius on the lowest point of the hose, no matter how far it has been pulled. This minimizes the chances of kinks in the hose and prolongs its useful life.

The supplied STL is for hose with outer diameter of 12.5mm or 1/2 inches or smaller, and it has a bend radius of 65mm. Please note the STL is for one half of the strain relief.

A .f3d file is available in case you need to make modifications.

Installation steps:

1. Print 2 copies of the strain relief halves.
2. Enclose the hose in the 2 halves.
3. Use zip-tie to close up the 2 halves.
4. Attach the weight to the bottom of the center zip-tie

Creality

Ender 3 Pro

No

No

0.28mm

20%