I needed to dig some cables in the ground and had that allready before, but from time to time the boxes i bought got water inside and the result was that my fuse felt out.

So I designed this small box where you can solder your cable inside or luster terminals and take easy buyable 2k Epoxy to put it and screw the lid on, Waterproof and no issue anymore, the wholes on the side you can drill on the size you need.

I printed it 100% infill, you don't need any support.

2k Epoxy you get everywhere in every home depot shop.

it uses around 25 mg of it to fill completely, the screws are 4 x 2.5" x 12

There is as well a single sized one under the following Link, for that you need 12.5 mg of Epoxy 2k to fill out.

http://www.thingiverse.com/thing:1585613