Dear all. I made simple and effective seed planter which is made out of base and cup. Print both parts together or separate. Cup contains holes for drainage. Base contains lifted ‘’cross'' for water disposal from cup. I will use it for Tomato all the way until it will go out in garden. This set also looks a little bit better inside in apartments on shelves etc. instead of some used food products like yogurth cup or something similar.

Material: PLA

Layer: 0,2 mm (or by choice)

Speed: 180 mm/s (or by choice)

Infill: 10% (or by choice)

Support: NO support

Enjoy printing and seeding your new plants for Spring.

Best Regards.