Novation Circuit Battery Door Replacement
caliperfan7
Mit KI Ähnliches finden
Druckprofil(0)
Modelldatei(0)
0
0
0
Veröffentlicht:2025-12-28 17:37:02
0
0
000Beschreibung
Modellquelle
Rezensionen(0)
Found a poorly cared for Novation Circuit? Well, I did. The battery door was gone, broken encoder, covered in dumb stickers. Apparently someone spent more time messing mine up than playing it.
So, I cleaned it up, replaced an encoder, and designed this battery door.
Print settings aren't too important since this is so small. But I'd recommend a low layer height for lots of strength. I made the tabs have a little less spring to keep the tiny bottom tabs from shearing off. The whole mess doesn't need to be that tight. Overall, it works.
See notes below for finishing this off.
(As a side note, Novation is an awesome company. When I needed an encoder to fix this, they sent me one free, no charge. So instead of this great Circuit ending up in a landfill, they helped me fix it and get it back on the road. THAT'S a cool company.)
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
50%
Filament: Hatchbox PLA Blue Post-Printing =============
Finish off with conductive material.
You'll need to add something conductive across the terminal tabs. Here, I've used some copper tape that I have available. You could wind some wire from terminal to terminal...whatever works.
Also, if you want to mimic the original a little more, you can sand the top snap tab to be sharper. I designed this so it would print without supports, so that tab has a taper. The real one is a sharp right angle. A little filing would sharpen that off. Door still works without it,Modellquelle
Original-Link: Details anzeigen
CC-BY