I wanted my tablet positioned higher up in a more natural viewing location on my Bowflex Max Trainer 6. Print both the right and left sides, then thread an M4 screw into the hole in the back of the models to position and gently tighten down on the right and left tubes, as shown in the picture. I use a tiny bit of packing tape on the tubes where the screw will touch to protect the tubes. This is designed for my 10" tablet, but will fit any size 7" or up. I also include the M4 Screw cap model for you to print. I affix the M4 screw caps to the screws with a tiny bit of glue.

Creality CR10

No

No

50 to 80%

These are pre-positioned. No supports needed. I print at 220C, Bed at 60C

Custom designed in Tinkercad