Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 150.05x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.3mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.3

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Matte Ash Gray Transmission Distance: 1.5

PLA BambuLab Basic White Transmission Distance: 5

This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #7 (0.64mm) swap to Blue Gray

At layer #11 (0.96mm) swap to Ash Gray

At layer #15 (1.28mm) swap to White for the rest.