Also a remix of a Screen Cable Clip I made so without wires run behind it it will likely move freely on the rail. I put a piece of 1/2in foam tap on the back and that gave it enough grip to stay in place on the rail while still having enough flex to pop it off. I would have designed it tighter but it likely would have been next to impossible to get off without breaking. The best way to pop it on or off as it is, is to use a paint scrapper/ print scraper to press the side in until in pops onto or off the rail.

It is designed for the face to be printed laying down and the case to be printed standing up so the snap wont break and it wont require any supports.

Category: 3D Printer Accessories