This is a case to hold a Sparkfun Weather Shield weather station and SpartFun Redboard Arduino, along with an Electric Imp IoT wifi cadaptor, Solar Buddy charger and LiPo battery. I received the parts for the SparkFun weather station 4 years ago and put them in a standard hobby box and have had it running on my house for the last four years. A failure of the solar cell resulted in me having to take it off the roof. I decided to make a new case for it before putting it back on the roof.
If you want to check out the running weather station it is ISTOKE4 on Wunderground

Prusa

Prusa Clone

Doesn't Matter

Doesn't Matter

course as you like fo the case

20%

There are two clear parts. The Ambient light pipe and the indicator light pipe. Print these with clear PLA filament. The files have a disk on the bottom to get good adhesion. That needs to be cut off once finished. I gripped the disk in a chuck to spin the part so that i could use sand paper to polish the parts. The clear parts need to be printed with 100% fill. It helps to wind the extruder temperature up to the max, or even a few degrees over, for the material to get good bonding. Run the extruder feed at 120%. My clear parts came out pretty well. They are a little cloudy but work well for light transmission.

All the parts are available from Sparkfun. They have excellent step by step instructions to get you up and running. https://www.sparkfun.com/products/13956