This is a remix of a case and mounts for the TFT35-MZ screen to fit on an ender 3 PRO. It mounts on the stock location and you may need four longer screws. the screws go in from the back and sandwich the mount, bac case, screen, and top case parts together. The reset button may need to be modified and you might have to make it a little taller or shorter to have a little play between the bottom on the back of the circuit board and the case.

No

No

0.16

20-30%

I only made cutouts on the back for the stock ribbon cable since I am not using this in touch screen mode and only used one cable to connect it. SD card and USB slot cutouts are incorporated into the bottom case piece.