I have a small problem with my heat bed connection on the TEVO Tornado. As the heat bed moves back and forth along the Y axis, the cable moves side to side twisting the connections. After several hundred hours of printing, the problem grew big enough to render the thermistor cable unstable enough to create a MINTEMP BED error.

So I created this clip to prevent the cable from moving side to side so badly.

This is sized so it fits snugly on the stock TEVO Tornado bed with the TEVO Tornado logo pad attached.

The top piece is: 35.1mm w x 70.3mm long x 15.6mm high.
The bottom is: 34.9 mm w x 83mm long x 11.5 mm high.

The bottom piece has a notch in the end for a zip tie to hold the cable firmly to the clip.

The screw holes are sized for a M3 x 20mm screws and just long enough to put on an M3 nut. Tip: Before attaching to the cable, run the screws through it once, or use M2.5 x 20mm screws as the holes printed a little snug.

TEVO

Tornado

Doesn't Matter

Yes

I put supports underneath the top clip holder and just one small set underneath the top piece cable half-pipe arch and printed it flat.