Made this for my Hypercube Evolution where I am using micro switches for homing everything.

I've got mine mounted for Z max homing, but they will work for Z min just as well.

Print instructions

Category: 3D Printing Print Settings

Supports: No

Notes:

They should be in the right orientation for printing.

You may need to mirror the switch bracket depending on where you mount. - Mainly depends where you want the cable tie feature to be.

Post-Printing

A long 4mm screw goes in the screw bracket. It is intended to go in very tightly so it doesn't move on you later.

The screw is supposed to make contact right above the red button on the switch for optimal accuracy.