I needed to mount my Filastruder Vertically and didn't want to drill some holes in it and mount it to a board.

1) This bracket is mounted to the backboard by 2x 4mm screws.

2) The Filastruder is clipped in using using the rear motor mounts and and gravity to hold it in place. This allows for easy installation and removal without modifying the filastruder.

Ive found since installing my filastruder in the vertical position that extrusions diameters are more consistent and less noodle fails due to filament brushing against something.

Print Settings

Printer:

E3d Bigbox Dual

Rafts:

Supports:

No

Resolution:

Infill:

25%

Notes:

I used e3D 0.8 mm nozzle to allow quick printing, but anything will work.

Post-Printing

Cleanup

To Install Filastruder

Step 1: Angle Rear of filastruder abd Locate Motor mounts into two holes of bracket

With Filastruder at 45Deg locate rear motor mounts into bracket and make sure that are firmly located into the bracket.

Step 2: Push down Front of filastruder

push down front of filastruder to locate into bracket

To Remove Filastruder

Step1: Lift Front of filastruder up at an angle

Step2: Lower Filastruder from motor mounts

Category: 3D Printer Extruders