This lucky wheel is divided into 13 parts - each can represent whatever you want. 

For better spinning use 608 bearing. Remove cages, remove old grease with IPA and lubricate it with runny silicon oil to ensure the smoothest action.

Printing:

Everything prints without supports and has no difficult geometries. Make the divisions as colourful as you can. You can add a text to them.

“Stand horizontal” and “stand vertical” you can print or make it from wood - which I opted to to save some filament.

Assembly:

Attach “stand horizontal” and “stand vertical” with two screws size 4mm. There are through holes as well as aligning holes so you do not have to find the right location, where to screw it together. 

Use super glue to attach 13 “divisions” to the “body”. Then on another screw insert in this order - “holder front” - 608 bearing - “body” - “holder back” - and screw it to the hole on the stand.

Than just screw “finger holder” to the stand and press in the “finger” and you are done.