A carrier for 5 magnetic micro mounts. The lid snaps in place, if needed it can additionally be secured with zip-ties or rubber bands. Very handy to transport or send samples to other labs.

There is enough tolerance to print this at higher speed / lower quality. The print in the foto was done with 0.2mm, 50mm/sec, 20% infill.

Make sure to rotate the lid for printing, so the top is facing down (sorry for that, I lost the design file).

Print Settings

Printer Brand:

Ultimaker

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2mm

Category: Learning