Thanks for stopping in!

Please come back and post your makes! It motivates me and allows you to show off. It also encourages others to print it.

I try to give you options here. That and the design work takes effort and time. Feel free to buy me an Ice Tea if you like by clicking that tip designer button. More filament means I can run more test prints!

There are three options.

Hollow: use this one if you have a smaller nozzle or don’t like vase mode. Try three different colors.

Solid: use this one for vase mode, especially if you have a 0.8mm or larger nozzle. Try different colors!

One piece: if you don’t want 3 colors and the illusion of three separate pieces use this one. I hid the connection points so nobody will know.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2 as shown, smaller is better

Infill:

Filament: Hatchbox Pla as shown - but any Multiple Post-Printing =============

These twist together. Hold one above the other, align them and gently twist down. This isn’t supposed to be a torture test or a calibration test. It is supposed to look like three pieces. It should go together easy.

Category: Sculptures