Why should you print this? 

For your best/favourite/fastest 3D Benchy, you need an appropriate display!

Filament

Material: Any, but I recommend PLA;
Colour: Also any, but I recommend: Nozzle–Metal, Sea–Blue;

Print Settings

Nozzle: 0.1 mm, 3 perimeters, 15% infill, with supports
Sea:  0.25 mm, 2 perimeters,  15% infill, no supports

Post processing

Glue the nozzle part to the sea using the small pin in front of the model. If hole in the nozzle is too small for the pin, you can make it bigger by heating a cork board pin and piercing the hole.