This is a wall-mounted hook for the  Hario V60 Drip Scale. It has guide wings that guide the scale to the hook. Easy to use, no fiddling.

• Looking for a mount for Ikea Skadis pegboards instead? Check out the Skadis Mount.
• Looking for a version that uses Command Strips? Check out BirdmanTheWelder's remix.

Required Hardware

Printing

Print the parts in the original orientation. All STLs are pre-rotated for printing.

Recommended setting for 0.4mm nozzle.

• Layer height: 0.2mm
• Perimeters: 3 or 4
• Infill: 20%
• Extrusion width: 0.4 - 0.45mm
• Solid layers: 4 top, 4 bottom

Assembly & Installation

Apply some superglue to the cavity for the hook in the mount. Then push the hook through through the hole in the mount. Let the glue cure while applying pressure.

The hole distance is 70mm in case you need to drill pilot holes. Countersunk screws with a head diameter up to 8mm are supported.

The scale is hung onto the hook using the hole marked below.