This Stand is compatible with Lego figurines 2 pin "feet".
I got tired of my display figurines always "toppling" over without a 2x4 low brick under them and never liked the look of that in a display so I made this small little 2 prong circular stand for the figurines to stand on. Depending on your printer (mine is a monoprice mini v2) you may need to adjust the size of this to get a "snug" fit to the feet, minor increments of 0.05mm up or down in size will help or adjust the infill to less then 100 if to snug.

Monoprice

Select Mini

No

No

0.175

100%

Printed at 45mm/s