.05mm layer height. Printed with rectilinear sparse infill and Hilbert curve top surface(I have found other top surface patterns are too shiny for my liking) I use brims on all my Hueforge prints and rarely have any adhesion issues.

Swap Instructions:

Start with PolyLite PLA Black

2.15mm switch to PolyLite Orange

2.25mm switch to PolyLite White

You can resize the print to fit your needs just make sure the height stays the same to ensure you get the same layer colors.

I like saving filament so I also print the first 2mm at 0.2mm layer height and 25% infill and never have any problems with print quality. I chose to do the print a little thicker to make it more durable but you can definitely trim off 1.8mm from the bottom and still be fine.

Also as a note I made this in Hueforge version 7