Customized version of http://www.thingiverse.com/thing:139461

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing\_id=139461

Print instructions

Printer: Geeetech G2S Pro

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 70%

Notes:

Printed very cleanly with MakerGeeks high strength Raptor PLA. Insertion of the coin was difficult. I took a pick and tried to clean out the sagging bridge layer. Might have been better with layer cooling. Used the trick I read to use a pliers to push the penny into the slot.

Instructions

Using the following options:

CoinType = US
TextSpacing = 10
NumberOfRows = 1
build_plate_selector = 0
ManualOverhang = 3
ColumnSpacing = 0
build_plate_manual_y = 100
build_plate_manual_x = 100
NumberOfColumns = 1
Text = C7
ManualRadius = 9.5
TextHieght = 90
TextRelief = -10
Font = write/orbitron.dxf
ManualThickness = 1.75
TextPositionY = 0
TextPositionX = -30
RowSpacing = 0