This is an enclosure for a UART TTL board like this one [https://www.aliexpress.com/item/32801557756.html?spm=a2g0s.9042311.0.0.dcd44c4d4fxiCi].

In addition to the 3D printing I went through the trouble of making little "light pipes" for the 3 LEDs on the board. I used the "thick" clear plastic from typical chocolate boxes (e.g. Ferrero Rocher and the likes). Sawed and sanded until it fits in the little square holes in the enclosure. Secured with a bit of crazy glue. Adds a nice touch but by no means necessary.

Note that for a result where you can actually read the pin labels, you need a 0.2mm nozzle.

Print Settings

Printer Brand:

Anet

Printer:

Rafts:

No

Supports:

Resolution:

0.1

Infill:

Filament: Overture PLA Grey

Notes:

Category: Electronics