I created this simple model to make mounting the Govee Outdoor Lights 2 easier to mount. I attempted to use the provided mounts and screws but the screws wouldn't hold and the tedious nature made me think there must be a way to use a brad nail gun to mount the lights. I mounted mine every 2 or so lights or wherever the wires hung too low. 

Printing

I printed with a 6mm nozzle and .25mm layer height, any settings and nozzle will probably work fine, the important part is to make sure it prints lying flat which will require bridging, but if it is printed on its side the layers are more likely to split when nailed to your home. that being said as long as your printer is tuned well enough for bridging, it is a fairly simple print, I printed about 30 at a time but could have filled my entire print bed if needed.

Also, the wholes didnt print properly when I printed them likely to them being too small, but the nailer had no problem going through the plastic. granted I did only use PLA. 

please let me know if you have any questions