Notes from my original tinker:

This is a fidget spinner of course.... the center uses 2 standard 608z skateboard bearings or similar (22 mm x 7 mm) stacked back to back. Used an old pencil drawing as inspiration that typically keeps me occupied when i sit and doodle; and has for many years. Most likely picked the shape up from a old math class eons ago.

Hope you enjoy, hard let me know if I screwed it up anywhere my eyes hurt after staring at it for a while!

Version 1 has more faces than version 2; also version one the bearings sit outside the frame intentionally.Center hole still takes 2 bearings stacked and the exterior holes are for 1 bearing.Use cheap bearings in the outside just for weight and slow spinning.

Version 4- added some extra bearings for weight and longer spinning - same size as the others 7mm x 22mm. If you print it standing up it yields good results with a raft and supports. Might have to clean inside the bearing housing a bit or scale it up to 101% depending on your printer. It's a bit delicate when its done so use caution when installing bearings.

QIDI X-ONE

Yes

Yes

.15 to .20

30% to 90%

Printed in PLA and PETG 50mm a sec with supports for the steps on the bed as it begins, prints best standing up but that will require a raft and supports in most cases. Laying flat I have trouble getting good results on the bottom side.