This is just a blatant copy/remake of an awesome little tool! Just a tad taller!

Original item -(red one in the images)
https://www.thingiverse.com/thing:280974

The original was great but for one thing, after I added a glass bed it ended up being shorter than the end stop for the Z axis. SO I made a slightly taller one.

Just did a write up and video on use of this tool...
http://3dprintingllama.blogspot.com/2017/04/square-level-x-and-y-axis-before.html

what it does- It checks the alignment of the X axis rods to the rods in the Y axis to make sure they are square/level to each other. Use before leveling the bed to get a MUCH better and more accurate leveling.

Clip on the Y rods and lower BY HAND the Z down till the X rod just touches, go to other rod on Y axis and adjust..

never do this with power, you can severely damage the printer by bending the rods if you use the motors!!.

Print instructions

Unassociated tags: X axis
Category: 3D Printer Accessories