Alternative display mount for the Anycubic Vyper which is compatible with the "Flexi-Arm Camera Mount" by mkoistinen.

This is the single connection version. If you need a dual connection, you can find it here.

How to assemble:

1. Unplug the display (or at least be careful with the cable)
2. Remove the 3 screws of the corner piece where the display is attached to the printer
3. Remove the 2 screws on the back of the display
4. Connect the Flexi-Arm camera mount piece (with the ¼" thread) to this model (it has quite a tight fit, be careful)
5. Use the 2 display screws to attach display and mount
6. Connect the Flexi-Arm elements to the display
7. Plug the display back in
8. Adjust the display position

Settings:

• RecyclingFabrik rPLA "Einsamer Wolf" @ 200°C
• Layer Height 0.1mm (adaptive)
• 20% infill

Print times:

• 1x single mount: 0:13h