Door Knocker Santa Hat

I designed this based on a suggestion from my brother-in-law. My family loves the personality it adds to our front door. :)

It took under 20 minutes on my printer with 15% infill, and 0.32 layer height. I didn't need to use supports thanks to the bizarre talent of 3D printers: bridging across even surfaces. At most I would use minimal tree supports. A simple filament swap a few minutes before it was done printing was all it took to finish the thing off. :)

If you all have any other ideas, please let me know! And hardly anything makes me happier than seeing designs that I made out there in the world, so please share a make if you print this off! :D

Enjoy!