Here are some of the TPU prints i made for my Fractal Engineering Wingman with Walksnail

I originally ordered the 10mm standoff version and madeit fit with the Walksnail VTX and Jhemcu GSF405, but i wasnt happy with the clearances, so i extended it by 2mm through some TPU spacers. Now there is more air flowing around the electronics, and less chance of damage in collisions.

GPS holder (two versions, one holds the GPS further forward, for if you use the original battery tray - i didn't so i put it a little further back, just personal preference)

Nanolite camera holder. This is a tight fit, be sure to fit it soon after printing as it will get hard if the TPU is cold/harder

Battery loops - half a gram each replaces the 8 gram battery tray (you'll need to solder power leads and a plug onto your 18650 batteries). I had to buy special 18650s for this project, so why use such a heavy battery tray. I added ziptie versions so you can use both 18650 and 21700 cells

Antenna holder - two versions. One holds the shipped Walksnail 1s mini antenna, this is actually quite light. The other is for using other antennas i guess - i use a HGLRC Hammer mini, after seeing someone do some impressive long-range with that antenna. You use a 4mm diameter straw to keep the antenna mast sturdy

Everything was printed in TPU 95A, 200 degrees no bed heating