This is a simple spool holder for the Flashforge Adventure 5M that mounts to the right side of the printer.  I had to drill a new hole in the AD5M enclosure to access the bottom screw/hole.  M4/20mm screws were used to mount it.

I wanted the holder to be as ridged as possible, so I went overkill on the layers/walls.

• Bottom layers - 5
• Top layers - 5
• Walls - 5
• Infill - 15%

I wasn't worried about the axle, so standard settings were used for that. Print 2 halves for a complete axle. Two 608 skate bearings were used to complete the build.

• Bottom layers - 3
• Top layers - 5
• Walls - 2
• Infill - 15%

Printed in PLA, it works great for me and prints without supports.

I was inspired by these models:

https://www.printables.com/model/1193462-flashforge-adventurer-5m-ad5m-improved-side-mount

https://www.printables.com/model/643541-ender-3-v3-se-ball-bearing-spool-holder