For the Ocelot ECU from WMTronics.

Simple case that Should get you started. This is my first contribution to the Speeduino Community.

There were enough tolerances in the design that I was able to take this part straight off the print bed and throw the ECU in. I hope this will be the case for you as well. Files should be orientated to their intended print bed placement.

Both of the tops will require you to drill a hole for onboard map sensor (if in use). The top with Bluetooth has a slot to slide in the typical dongle that you plug into your ecu.

The bottom is thicc and you will have to drill holes for your own mounting purposes. I was able to reuse mounting bolts/holes from my stock ECU.

Slice, print, install, ride. That was my goal here :D